Weather pro awning

You will keep your awning safe from the wind and rain! Automatically retracts to prevent damage from wind! To prevent damage to the awning or coach, a wind sensor closes the awning automatically when it detects high, sustained winds. Choose a color, select a size and add your hardware. You have have just made a great power awning purchase.

The control kit comes with a hand-held wireless remote that opens and closes the awning with ease. There is also a built-in solid state wind sensor which will automatically retract the awning in high winds, protecting your awning - and ultimately your RV. My awning is years old and already shows wear. Noticed your new awning is one piece, mine, from AE has a seem in the middle that has stretched and now shows fabric of a different color in the seem.

I will get a new awning the next time I drive through Vancouver WA. Awning works with remote switch 1. Circuit Board Wiring Section 3. Key FOB Programming Section 5. The awning extended fine and was out for four days. When I went to retract upon pressing the button, the motor groaned and quit. Your awning info should be on the inside of the tube near the motor. Inside the arm near there is a rubber connector with two wires.

Unplug it and If you can measure volts there when the switch is depressed and the volt polarity reverses when the switch is depressed the other way it must be th motor. Always make sure the awning is fully extended be-fore opening the entry door. The facto-ry preset setting is MPH.

Here is a quick check: the circuit board in the control box contains an audible alarm to alert the user when there is a problem with the wind sensor or wind sensor cable. We have had the same symptom with our Weather Pro awning several times that was fixed by different things. Once there was a corroded connection on the motor - it is located on the end of the awning (end to the front) and on some models water can get inside. Once the spring (opposite side of the motor) had to be tightened - a pretty dangerous job.

Fill Your Cart With Color Today! A new board was ordered and installed on Friday. AE Dometic Weatherpro awning hardware Standard installation kits are easy to install and will work on any dometic AE weatherpro rv awning system.

This product is made of high-quality materials to serve you for years to come. Designed using state-of-the-art technology and with customers in mind. How to install a motor on an electric Dometic RV awning ? If the wind sensor is defective the patio awning will only retract and not extend unless another vdc power source is used. There are two places on my Weather Pro to find the information.

With the awning fully extende standing under the awning , look up the front arm to the roller tube. There may be a sticker there, on the roller tube, with the information. The brand new unit was hooked to the original AE control box.

From the start the awning did not work properly. STEP 1: Click the awning or slide-out topper that most resembles yours. Roll the awning completely out on a clean smooth surface. Note: Use needle nose pliers to remove the poly rope from the groove(s) of the roller tube before removing fabric.

WeatherShield Assembly Removal And Replacement (On WeatherPro Only) 1. Extend and retract your awning effortlessly, at the touch of a button. CALL FOR SIZES OF USED AWNINGS , 10s IN STOCK. Possible scratches or scuffs.

All motors are tested for proper operation prior to shipping. PLEASE SPECIFY WHAT COLOR YOU WOULD LIKE SHIPPED! User manual DOMETIC WEATHERPRO. Press and hold the Extend button for seconds and the awning will automatically open. If not held for three seconds.

Slideout and window awning protective covers and other accessories. Low cost shipment methods available. Since they’re smaller than main awnings (and even most slide toppers) window awnings are particularly easy to replace yourself, at a particularly reasonable cost.

Obviously, the labor is free when you do it yourself.