Line lock install

This is their recommendations for correctly connecting a line - lock for your brake system. Note: If using an aftermarket brake system, a residual valve type master cylinder must be used. Proper instal­lation is required.

Do not drive vehicle until the brake system has been tested. This feature is not available right now. Solidly mount the solenoid to the car away from headers or excessive heat. Since I am only locking the front tires and only worried about preasure to the rear brakes this was the easiest way for me.

At the drag strip, a line lock is almost a must, as you need a way to lock the front brakes and spin the rear wheels to put some heat into them. With this Hurst Line Lock , you can get a great and easy to install line lock, which will significantly help your performance at the track. FREE Shipping on eligible orders.

Cap one port at the valve, run a line from the linelock In port to the open port on the valve. Then using a T connect the lines from the front brakes together along with a third line going back to the line lock out port. By the way I have the instructions along with a picture diagrams of the brake system.

I have separate lines from the master cylinder to the front and rear brakes. The line - lock is nothing but a solenoid valve in the front brake lines which is energized (closes) on pressing the switch near the shifter. It is used at the line and in the water box. Outdated Internet Browser Detected. Your web browser appears to be out of date.

Soon you will not be able to create a secure connection to our web site using TLS 1. Sold separately, see the drop down menu option above. But the Hurst Line Lock Solenoid is $111. That should give you some idea. Hurst also sells an installation kit for $27.

First drain the brake fluid from the master cylinder reservoir by either sucking the fluid out from the top or removing the rear brake line and letting the fluid drip into a cup. Controls the front or rear brakes. The center wire goes to the line lock solenoid and the bottom wire goes to the power source. A line lock is a device that allows.

I ran all three wires from the headliner, down the pillar post, behind the weather stripping in the corner of the dash and down to the bottom of the dash. It is pretty simple but I thought I would do a short write up on the install. The installation is pretty easy. If you can afford it, get an installation kit, which usually includes all different types of fittings. BTW, I did several burnouts without using a line lock and when I checked my brand new rear brake shoes, one shoe on each brake was worn down way more than the other one.

Two kinds of brake line locks are most common in. Brake Line Lock Ball valve vs. One major consideration in buying a brake line lock is the amount. The brake line lock is usually sold in a kit with other tiny parts. These Fox Body performance kits lock up the front wheels making it easier to heat up your tires in the burnout box and keep you from rolling through the lights in the staging lane.

I am debating on an electronic line lock or a manual pressure one. The electronic is an easy install because it is just a wired switch in the cab. A manual one is different.

I want to install a line lock on the front brakes. I wanted a mount and location that was out of the way and would hold the Line - Lock ridged so it would not move or vibrate and not require a lot of extra brake lines. All of the main pieces are included to mount and wire the line lock , excluding extra wiring.

This enables you to choose where to mount your line lock without worrying about wiring being too short. A roll control is bascially just a solenoid activiated by a driver controlled momentary contact switch. Line Lock Installation: Now you are ready to install the line lock or roll control. Re: Line lock installation master to line lock to valve.

I installed two line locks right before the forward brake lines on either side. The solenoid keeps the front brakes locked while releasing the rear brakes. Im thinking of installing a line lock. And on the line lock site it says you.

I finally took the plunge and bought a line lock from Cartek, nice piece and complete kit. Here are photos of the install. The only thing I changed was the means of activating the line lock.