Adjusting pocket doors

A pocket door adjustment takes a few minutes and a couple of tools. This article will help you to understand which way the door will move when you adjust it. This video describes how to gain access to the height adjusting nuts for a pocket door.

For more of my videos, type Lsailorin the search bar. Use a ladder and a flashlight to examine the rollers. The first step to adjusting a pocket door is closing your door and then inspecting it.

You will need to look at the top of your door. See if you can get to the rollers which are on the top area of your door. You need a pocket door wrench when you work on you pocket doors. The thin profile will fit in the tight space above the door. You use the wrench to adjust the bolts on the pocket door hangers up or down.

The problem with adjusting a pocket door is accessability in the hidden part. That way I can pry it out if need be, without messing up the casing. From what I have been able to discern with my pocket doors of the exact same type, the unit lowers as you turn the screw cw and raises as you turn it ccw.

Many pocket doors can be adjusted with special tools from around the top of the pocket frame with the door in a partially closed position. These tools are often specially angled wrenches designed to fit into that little gap. One door will not stay closed.

Another will not stay open. The doors are hollow core, panel interior doors. It slides out of the pocket. Is there an adjust that can be made? It sounds like it is the track.

Most sliding doors have a mechanism called an adjusting screw located at the bottom of the door ends. Turning this screw raises or lowers the roller. Give the screw a clockwise turn and test to see whether the door slides easier.

Raise it just enough to clear the track and roll smoothly. All of these pocket door problems can cause a person or a friend to avoid using pocket doors. This distrust can often be blamed on poor hardware quality or poor installation practices. The names of manufacturers and inventors are provided.

Inside a standard sliding glass door there are adjustable rollers that help it slide back and forth on the track. There are holes on your sliding glass door that conceal the adjusting screws to these rollers. On my door the holes had plastic plugs in them. Top-hung doors are far more common than floor-track doors. Thanks to a proliferation of pocket - door hardware manufacturers in the late 19th century, the mechanisms vary more than those for floor-track doors.

That sai there are three basic types: single roller, double roller, and trolley style. If after first adjusting the hinges you find the door lining is tight and the door is too wide it will need to be removed and the edge trimmed in most instances with a planer (electric or smoothing hand plane). To swing one of the doors free (out of the wall), usually there is a wood or metal stop attached to the middle inside edge of the door turned at a right angle to stop the door Take a putty or flat bar and adjust the stop parallel with the door.

Adjusting a door that is too wide. How to adjust a sliding door. THIS PROBLEM USUALLY AFFECTS THE HEIGHT OF THE DOOR AND MAY BEREPAIRED BY ADJUSTING THE ROLLER HEIGHT. When a swinging door takes up too much space, just slip it inside the wall with a pocket door.

Install the door hardware and hang the door. Slotted mounting holes for horizontal adjustment of pocket door. For use with any door thickness. Remove the sliding shower doors. To do so, remove the plastic guide.

Depending on the type of shower door you have, the guide will either be located in the middle of the lower rail, or the guide rail will be on the door. Hold it against the jamb while you adjust the brackets as shown. Do the same on the other door.

When sliding closet doors are working properly, they give you effortless access to your clothes, shoes and furnishings. Unlike entry doors , sliding closet doors rarely have a bottom track. From humidity, to loose screws, to a settling foundation, a variety of factors can cause a sagging door.

Pocket Door Wall Mounted door Bi. A sagging position can create gaps, allowing drafts to blow through, or prevent it from lining up with.