Friday, July 27, 2018

How to install coil spring spacers

Try jacking the front of the truck up until both wheels are hanging free the coil spring spacer will bolt right to the springs. Jack the front end all the way up. You can pry the spring coils apart, any furthere than that and you may need to get smaller spacers, just use more to get a high enough lift. The spacers provide you with a few inches of road clearance, without your having to replace anything else on your vehicle.


How I installed a coil spring spacer using a spring compressor. The coil spring , used in conjunction with a spacer , can change lift height (due to wear or a change in weight), but the spacer will never change height. Easy to install : A spacer is as easy to. Coil spacers allow shock absorbers to operate through their normal range for longer life and proper response ratios. For a fine tune lift without replacing the springs , consider utilizing coil spring spacers.


Do not switch coil springs from side to side as some vehicles have a specific “right” and “left” coil spring. Check the coil spacer for proper fitment into the coil spring mount in the frame. Some vehicles have guiding tabs to center the coil spring in its top mount. These tabs may have become bent and need to be bent back to allow the spacer to properly fit in the mount.


Remove coil spring (26) coil spring bushing (27) from spring perch (17) and lower a-arm (12). Position kit coil spring spacer (28) on coil spring (26). NOTE: you may need to pry with a pry bar to get the springs out.


Installing coil spring leveling kit. TGC rear coil spring spacers installed. The factory ones are fine for the 1. There is a couple ways to install the bumpstops you can remove the old bumpstops. So I just got my spacers in the mail, but they came with absolutley no instructions. You will need a coil spring compresor.


This will safely keep the spring. Jeep Wranglers are great for many reasons. One of these reasons is that the. If it is not you may need to compress the spring before re- installing.


If used the coil spring compressor should still be on the spring in a compressed state. Make sure the spacer is centered in the upper mount and the bottom of the spring is properly nested in the receptor groove on the. I had OME rear springs , and they worked great but after installing the rear storage area, I started carrying all of the recovery gear, tools, and the other heavy stuff in the back.


Ensure all fasteners are tightened to OEM spec or the specs provided in the installation instructions for your kit. Place the coil spring spacer in the spring seat over the bump stop. Keeping the spring compressor on your spring , replace the spring in its original place, attaching the spring retaining clip.


The use of small coil spring compressor will help with the installation. A IS DRIVER SIDE AND B IS PASSENGER SIDE. The trick to making them easier to install is making sure that the coil springs are completely compressed. TIP: a coil spring compressor may help aid in putting the coil spring back in when installing the spacers. INSTALL THE NEW FRONT SPACER where you removed the coil isolator from.


How to install coil spring spacers

If the isolator is good you can re- install them or leave them out if bad. At JKS Manufacturing, we are committed to providing you with the best products available and your satisfaction is our first priority. Using coil spring compressors, compress coil spring until shock is loose on coil spring. Remove nut and shock from coil spring and upper plate.


Make sure to install the OE upper spring isolator as well to net the full 2” of lift. Raise the axle to slightly compress the spring. These natural rubber super coil spring spacers from Mr. Gasket have dual grooves to prevent them from popping out.


How to install coil spring spacers

This design allows easier installation , and makes for a safe way to restore your car to its original height. How to install coil spacers ? I always had issues with the spring tool hitting the coil pocket on OBS trucks. Supreme Suspensions - NEW Race Team Ram Lift Kit Front U. I ordered some coil spring spacers and installed them myself over this past weekend.


My front end is riding about higher now, it looks perfect. Coil spring spacers allow shock absorbers and struts to operate through their normal range for longer life.

No comments:

Post a Comment

Note: Only a member of this blog may post a comment.